1. Slide the Post Protector over the post. The Post Protector should slide easily over the post & the post’s bottom should contact the bottom of the Post Protector. NOTE: Post Protector’s are designed to project above grade or finished floor height. Be certain you are starting with a level building site!

CALL with any installation questions! 877-966-8768

2. (4) 3/8” galvanized lag screws with sealing washers are provided for each post. There are (2) lag locations located between the “horizontal” ribs on the Post Protector’s lower section. Continue lag pattern with lag #3 & #4 (see diagram) The lags will join Post Protector to post to utilize the integral post uplift protection. Pre drill a 1/4” perpendicular hole through the Post Protector & into the post. Install 3/8” lag and allow the sealing washer to snug the Post Protector sidewall to the post.

3. Drill out drainage holes dimples. These dimples are centered on all (4) sides of the base “horizontal” uplift rib. They allow drainage for rainwater running down the post & through the Post Protector. We suggest 4” – 6” drainage stone for initial backfill.

4. Set the post in a typical posthole with desired footing & backfill material.

5. Set your string line “above” the top edge of the Post Protectors to align the posts. Or, you may also use a roofing nail or screw to draw the Post Protectors firmly & uniformly against the “outside” of the posts to be sure the string line post alignment is accurate.

6. Post Protectors will show that your postholes vary in depth. If you want the Post Protectors at a uniform height, simply measure & mark to desired height. We suggest 4”-6”. Trim by dropping a horizontal sawzall blade on (4) sides, then a vertical cut with a utility knife to remove excess material.

7. Any unique installation situations or any questions – 877-966-8768.

PRINT INSTRUCTIONS: Download the Post Protector post frame installation instructions in PDF format here.